Yeti Cycles 575 Owner's Manual page 13

assembly Cont.
frame assembly place the shock assembly onto the bike in the
9
configuration shown to the right. slide your first 33mm female bolt
and washer through mounting position one to hold the shock assembly in
place. now swing the dogbone into mounting position two. slide the other
22mm female Yeti bolt and washer through the mounting hole of the bike.
tap the 22mm female Yeti bolt into position with the dead blow hammer.
note: all female bolts and the main pivot are installed from the drive side
of the bike.
frame assembly thread the male Yeti bolts into the 22mm female
10
bolts and tighten down with 5mm allen keys.
note: the shoulder on the bolt should not be visible. the bolt should
fit flush against the frame. Be careful when tightening, make sure the
shoulder of the male bolts do not bind or bend the washers.
.
frame assembly First slide the swing arm over the main pivot
11
as shown, notice the recess cut in the swing arm in front of the
bearings. the recess should be lined up over the main pivot lip to ease the
installation process. slide the seatstays over the steel pivot pin. now slide
the 41.2mm female Yeti bolt and washer through the seatstays and shock
assembly. place a male Yeti bolt with a washer on the non-drive side of the
bike. tighten down both Yeti bolts with 5mm allen keys.
note: assemble this first so the seatstays don't hit the frame when
hammering in the main pivot pin.
frame assembly Make sure the bearings are lined up with the main
12
pivot before tapping the lightly greased main pivot pin through the
frame with the dead blow hammer.
tip: Use your left index finer to align the main pivot while installing.
assembly 26
frame assembly install the black washer and button head bolt over
13
the main pivot pin as shown. Cinch the button head down with a 5mm
allen key while holding the main pivot with 6mm allen key.
the last step is to install the derailleur hanger and water bottle bolts.