Table of Contents
Advertisement
assembly
linkaGe assembly slide a washer, press-cup and press-cup insert
1
onto the threaded bolt of you linkage tool.
linkaGe assembly place two of the dogbone bearings (300020029)
2
and the 1.38'' steel pin onto the threaded bolt as shown. now put on
the linkage tool washer and nut (200020071). at this point tighten down the
assembly with two 1/2 inch wrenches.
linkaGe assembly the procedure in step two produces a relief,
3
shown on the right, that aids in the assembly.
linkaGe assembly slide one of the black nylon washers
4
(300030100) onto the steel pin flush against the inside edge of the
bearings.
assembly
24
threaD PreP Yeti recommends prepping all bolt threads
at once on your work bench with loctite or grease. this will
ensure that all bolts are used in assembly. the medium
strength (blue) loctite formula along with proper torque is
ideal to keep the bolts snug.
linkaGe assembly place the dogbone over the shock with the
5
counter-bored holes facing out, what would be back towards the
seat tube, and the threaded end facing towards the shock. slide the pin
subassembly into the shock eyelet as shown.
tip: You will need to press evenly using your body weight in order for the
steel pin to slide through the garlock bushing in the shock eyelet.
linkaGe assembly once you have the pin subassembly started
6
into the shock eyelet, you can slide the threaded bolt, press-cup
and press-cup insert configuration from step one through the steel pin
subassembly and shock. on the opposite end of the bolt, slide a second
nylon washer, the remaining two bearings, press-cup insert, press-cup,
washer and nut.
linkaGe assembly Use two 1/2'' wrenches and torque the linkage
7
together until the bearings press into position. Make sure bearings
are flush on both sides of dogbone. this will ensure proper alignment of the
swing arm once it is installed.
linkaGe assembly insert the small socket head cap screws
8
(300030056) into the dogbone and torque down with a 2.5mm allen
key. Make sure to prep the bolts with loctite.
torque spec: 125-150 inch/pounds.
nylon washers
Advertisement
Table of Contents
