Begin Analyzing - Honeywell HX3 User Manual

Begin Analyzing

Press the Analyze dome switch within 15 seconds of inserting the battery in the Analyze pocket to start the Analyze (Charge
– Discharge – Charge) process.
If the analyze dome switch is not pressed within 15 seconds, the battery will be charged, but not analyzed.
The Analyze progress LEDs indicate the battery capacity as a percent of the original value. When all LEDs are off, the battery
capacity is less than 50%.
When the Analyze dome switch has been pressed, the Analyze LED will illuminate Red to indicate that the battery testing has
started.
As the analysis proceeds and during the discharge activity, the four progress LEDs at the side of the battery pocket will
illuminate in sequence to indicate the capacity of the battery .
The Analyze LED is Green when the process is finished.
The battery is then ready for use provided the capacity is acceptable.
Between 90% Between 80%
and 100% and 90%
Green Off
Green Green
Green Green
Green Green
Between 70% Between 50%
and 80% and 70%
Off Off
Off Off
Green Off
Green Green
Less than 50%
Off
Off
Off
Off
1-11