Support Software Problems; Battery Replacement - Procomp BIW2A User Manual

Table of Contents

Advertisement

Troubleshooting & Technical Summary

Support Software Problems

There is a variety of software on the Support Disk.
If you install the wrong software, the motherboard
and the system may not operate properly.
Make sure you check the following:
Bus Master driver: You must install the correct
driver for the operating System you are using.
VGA driver: You must install the correct driv-
er for the operating System you are using.
Audio driver: Check that you have installed
the correct driver. If the motherboard has the
enhanced Creative audio chip, you must in-
stall the Creative audio driver. All other ver-
sions of the board use the ADI driver.

Battery Replacement

This motherboard uses a CR2032 Lithium coin
battery to maintain the system configuration re-
cord created by the BIOS CMOS Setup Utility.
The battery should last for several tears. If the bat-
tery fails, the system will not be able to retain the
system settings and will not operate properly. If
this happens, do as follows:
Turn off and unplug the system.
Open the system and locate the battery on the
motherboard.
Remove the old battery and dispose of it
properly.
Install the replacement battery with the posi-
tive side (marked with a + sign) face up.
Reassemble the system and reload the Opti-
mized Defaults in the CMOS Setup Utility.
5
61

Advertisement

Table of Contents
loading

Table of Contents