Other Connections - Procomp BIW2A User Manual

BIW2A User' s Manual
Always connect the Pin 1 side of the ribbon cable
(the colored edge) to the Pin 1 side of the cable
connector on the motherboard or device. The Pin
1 corner is marked on the motherboard and IDE
devices usually have it marked in some way. The
rule of thumb for IDE devices is that the Pin 1
side of the connector is on the drive power con-
nector side.
The end drive connector on the ribbon cable is for
the Master IDE device and the middle connector
is for the Slave device. The supplied cable supports
IDE devices in all modes.
If you want to install devices on the second IDE
channel, you will need to purchase an additional
IDE ribbon cable. If you want to use IDE devices
that use the UDMA66 data transfer mode, you
will need to get a cable that specifically supports
UDMA66.

Other Connections

There are several other connection points on the
motherboard which you will or may need to use.
These include the connector for the second serial
port' s port bracket, the CD-ROM drive audio in-
put connectors, the IR port connector, Wake-up
On LAN (WOL) connector and the connector for
the TV-Out port bracket on the BIW2A-AT.
26