Disk Drive Connections - Procomp BIW2A User Manual

BIW2A User' s Manual
Connecting ATX Power
The power connector from the ATX power supply
is a rectangular plastic connector with multiple
wires running back to the power supply. It plugs
onto the ATX power connector on the mother-
board. The connector will only plug on one way,
so if it won' t plug on easily, turn it around and try
again. Make sure the power supply is unplugged
when you connect the power lead.
Connecting Cooling Fans
There are two connectors on the motherboard for
connecting power leads from system cooling fans
mounted in the system housing. The system
housing may already have such a fan installed. If
so, you should connect it to the nearest connector
on the motherboard. Many cases have a space to
install a standard cooling fan. The fan power leads
will only plug on one way so you can' t connect
them incorrectly.
Fan Out +5V GND

Disk Drive Connections

This motherboard has three connectors for disk
drives, one for up to two floppy disk drives and
two EIDE connectors which can connect to two
IDE devices each for a total of four. The mother-
board comes with two ribbon connector cables,
one floppy cable and one IDE cable.
24