Table of Contents
Advertisement
i
®
By selecting "LOGIC7
OFF", all compatible
formats as they are present on the medium are
played back. Due to the vehicle's spatial charac-
teristics, an optimal sound experience is not en-
sured on all seats.
Adjusting surround sound
With surround sound, you can choose be-
®
tween "LOGIC7
ON" and "LOGIC7
Select "Sound"
"3D Sound".
Adjusting surround sound
1 Current setting
Selecting a setting: Slide
rotate ymz.
Saving setting: Press n.
The setting is saved and the menu is
closed.
Exiting menu without saving chang-
es: Press L or slide omp.
®
OFF".
i
Please note the following:
For an ideal sound experience at all seats,
the balance and fader should be adjusted to
the center of the passenger compartment
®
with LOGIC7
switched on.
The best sound results are achieved by play-
ing high-quality audio CDs and audio DVDs.
For MP3 tracks, the bit rate should be at
least 128 kbit/s.
Surround sound does not function for
mono-signal sources.
In the event of poor radio reception quality,
e.g. inside a tunnel, you should switch off
®
LOGIC7
, as a dynamic switch from Stereo
to Mono could occur, resulting in temporary
sound distortion.
COMAND introduction
rmq
or
With some stereo recordings, the resulting
sound may deviate from conventional stereo
playback.
Switching off/on the audio source
i
When you insert an audio CD or audio DVD,
it automatically becomes the active audio
source.
Switching off: Select "Audio"
dio"
"Audio OFF".
The audio source is switched off; "Au-
dio OFF" appears in the display.
Switching on: Select "Audio", then the
desired audio source.
or
Load CD/DVD ( page 116) or a
PCMCIA card ( page 117).
Control systems
"Au-
97
Advertisement
Table of Contents
