Nvr Installation; Hard Disk Installation - HIKVISION DS-8600NI-8 Quick Operation Manual

Quick Operation Guide of Network Video Recorder
Thank you for purchasing our product. If there is any question or request, please do not hesitate to contact
dealer.
This manual is applicable to the models listed in the following table.
Series
DS-7600NI-E1/E2 series
DS-7700NI-E4 series
DS-8600NI-E8 series

NVR Installation

During the installation of the NVR:
1. Use brackets for rack mounting.
2. Ensure there is ample room for audio and video cables.
3. When routing cables, ensure that the bend radius of the cables are no less than five times than its diameter.
4. Connect both the alarm and RS-485 cable.
5. Allow at least 2cm (≈0.75-inch) of space between racks mounted devices.
6. Ensure the NVR is grounded.
7. Environmental temperature should be within the range of -10 º C ~ 55 º C, 14º F ~ 131º F.
8. Environmental humidity should be within the range of 10% ~ 90%.

Hard Disk Installation

Before you start:
Disconnect the power from the NVR before installing a hard disk drive (HDD). A factory recommended HDD
should be used for this installation.
Up to 8 SATA hard disks can be installed on your NVR.
Tools Required: Screwdriver.
Steps (for DS-8600NI-E8):
1. Remove the cover from the NVR by unfastening the screws on the back and side.
Models
DS-7604NI-E1, DS-7608NI-E1, DS-7616NI-E1
DS-7604NI-E1/4P
DS-7604NI-E1/4N
DS-7608NI-E2, DS-7616NI-E2, DS-7632NI-E2
DS-7608NI-E2/8P, DS-7616NI-E2/8P, DS-7616NI-E2/16P,
DS-7632NI-E2/8P
DS-7608NI-E2/8N, DS-7616NI-E2/8N, DS-7632NI-E2/8N
DS-7708NI-E4, DS-7716NI-E4, DS-7732NI-E4
DS-7708NI-E4/8P, DS-7716NI-E4/16P, DS-7732NI-E4/16P
DS-8608NI-E8, DS-8616NI-E8, DS-8632NI-E8
6