Pairing The Microphones - VocoPro SmartTVOke Owner's Manual

Pairing the Microphones

If the Microphones experience signal loss or drop outs, the microphones should be resynced to the receiver .
In doing so, the receiver will automatically change the operational frequency of each mic .
FOLLOW THE STEPS BELOW TO RESYNC THE MICROPHONES WITH A NEW FREQUENCY CHANNEL.
1 . Power the receiver on - Press power button once (1x) .
2 . Select which Mic channel to be paired:
Note: The flashing receiver LED denotes which Mic channel to be paired .
A . Selecting Mic 1 to pair
i . Press and hold Power/Pair ID button on receiver until the Mic 1 receiver LED is flashing.
B . Selecting Mic 2 to pair
i . Press and hold Power/Pair ID button on receiver until the Mic 2 receiver LED is flashing.
3 . When the desired Mic channel LED, Mic 1 or Mic 2, has been selected for pairing, turn on either
handheld microphone to assign the microphone to that Mic channel .
Note: The channel indicator lights on the receiver will then flash and the receiver will power off. This is normal.
4 . Power the receiver back on and check that the Mic channel LED is solidly lit on the receiver; this indicates
the microphone was paired successfully .
5 . Repeat steps 2-3 for the second microphone .
Notes:
• When pairing, only one microphone can be paired at a time.
• The receiver WILL shut off when it pairs with a microphone, this is normal.
• The receiver will power off if the Power button is continued to be pressed down once the flashing LED has selected Mic.
1
2
3
4
13