Amplifier Gain - JVC KW-AVX820 Instructions Manual

Volume Adjust
*1
Subwoofer Level
High Pass Filter
Crossover
Amplifier Gain
*2
Rear Speaker
*3
Fader:
Adjust the front and rear speaker output balance.
• F6
to
R6;
Initial.o
• When using atwo-speaker system, set the fader to the center
(.0).
Balance:
Adjust the left and right speaker output balance.
• L6
to
R6;
Initial.o
Press
[.~/
.../.....
/~]
or drag
[$]
to adjust.
Adjust and store the auto-adjustment volume level for each source, comparing
to the
FM
volume level. The volume level will automatically increase or decrease
when you change the source.
• <Fix>
appears if an
FM
broadcast is selected as the source.
• -12
to
+
12;
Initial
00
Adjust the subwoofer output level.
• -06
to
+08;
Initial
00
• Through :
Select when the subwoofer is not connected.
• On : Select when the subwoofer is connected.
Select the crossover frequency between the front/rear speakers and the
subwoofer.
• 80Hz, 120Hz, 150Hz
You can change the maximum volume level of this unit.
• Off
Deactivates the built-in amplifier.
• Low VOL 00
to
30
(Select this if the maximum power ofthe
speakers is less than 50 W.)
• High VOL 00 to 50
You can activate/deactivate the rear speakers.
• On : Activate the rear speakers.
• Off
: Deactivate the rear speakers.
*1
For 'DISC/USB": You can make the adjustments separately depending on the audio format-Dolby digitallMPEG
Audio and the others.
*2
The volume level automatically changes to "VOL 3D"ifyou change to <Low> with the volume level set higher than
"VOL 3D."
*3
This setting takes effectonly when Dual lone is activated.
rt!J
37)
20