OBH Nordica Q Mixer 6632 Manual page 30

Cleaning and maintenance
The removable parts, such as the glass jug, the lid and the filler are dishwasher
proof. Wipe all parts thoroughly before storing them. Do not use chemical
detergents or other scouring products. Remove difficult spots after a brief soak
and rub with a mild detergent and a soft brush. Use a damp cloth for cleaning the
motor part. Let it dry completely before you use it again or put it away.
Remove the knife holder from the glass jug and clean it separately as follows:
put the glass jug upside down and loosen the locking ring underneath the jug.
Separate the knife part and the gasket from the locking ring.
Note that the knife blades are extremely sharp. The knife holder and the
locking ring are dishwasherproof. The gasket should, however, be cleaned
with water and a mild detergent. Wipe all parts thoroughly after cleaning.
Assemble the mixer after cleaning by first putting the glass jug upside down. Pull
the gasket onto the knife holder and position the knife holder with the gasket
and locking ring in the opening at the bottom of the jug. Screw the locking ring
onto the jug until it is completely tight. Check that it is properly fastened. Put the
glass jug back on the motor part.
IMPORTANT! After mixing of ice cubes the glass jug should be cleaned in
lukewarm water, as the jug has been cooled and hot water may cause tensions in
the glass that may make it burst.
IMPORTANT! NEVER IMMERSE THE MOTOR PART IN ANY KIND OF LIQUID!
Disposal of the appliance
Legislation requires that all electrical and electronic equipment shall be
collected for reuse and recycling. Electrical and electronic equipment
marked with the symbol indicating separate collection of such equipment
must be returned to a municipal waste collection point.
Warranty
Warranty according to current law. Any claim shall be accompanied by the cash
receipt with purchase date. When raising a claim the appliance must be returned
to the store of purchase.
30