Using The Protective Sheet While Scanning; Editing Photos After Scanning - Brookstone iConvert Instructions Manual

4 . Slide the photo into the SCAN PAGE FEED face up, with the left side
of the photo touching the left edge, and press the SCAN button .
5 . The scanner will pull the photo through the scanner . At the same time
a window will show a downloading bar for progress of the scan .
hint: if you have several photos to scan, check the box "continuous scan"
in the digiphoto settings window before you start to scan.
note: the changes you make in the digiphoto settings window will be saved.
even if the scanner is disconnected, photos will be scanned with the settings
you previously configured.

UsING ThE PROTECTIVE shEET WhIlE sCaNNING

If you have an older photograph, one that may be delicate, curled or bent, and not
easy to load into the scanner, use the PROTECTIVE SHEET while scanning .
1 . Center your photograph face-up under the film of the PROTECTIVE SHEET,
pushing the top of the photo to the hinged edge .
2 . Scan the photo, as described previously, in the PROTECTIVE SHEET,
lining up the black hinged edge toward the center of the scanner first .
EDITING YOUR PhOTOs afTER sCaNNING
Your computer should automatically open your newly scanned photos in an editing
program currently on your computer .
If it does not, you may go to www . p icasa . g oogle . c om and download a free version
of their editing software to edit your photos .
Follow the instructions for editing in the editing software and save to your computer .
10