Calibrating The Scanner; Using The Scanner - Brookstone iConvert Instructions Manual

CalIbRaTING YOUR sCaNNER
1 . After the computer restarts, you will be prompted to calibrate the scanner .
2 . Insert the special calibration sheet (included) face up in the SCAN PAGE
FEED of the scanner, with the left side of the sheet touching the left edge .
3 . Press the OK button .
4 . Follow the on-screen instructions to complete the scanner calibration .
note: if the scanner installation is not started and displayed automatically
on the screen, click "start", select "run" and type in [d:\setup].
5 . To calibrate the scanner after the first use, right click on the DigiPhoto icon
and select "Calibrate" from the pop-up menu . Insert the calibration sheet
and press OK .

UsING ThE sCaNNER

1 . After you connect your scanner to your computer via USB, the Settings
window will pop up . Make any desired adjustments in the DigiPhoto Settings
window, including Brightness, Continuous Scan, Contrast and DPI setting of
either 100, 300 or 600 (300 being the default) .
note: the higher the dpi setting, the longer the scanner will take to scan your photo.
2 . If the Settings window does not pop up automatically, double click on the
DigiPhoto icon, or right click on the DigiPhoto icon and choose "Settings"
in the pop-up window . Make your adjustments and click "OK" to continue .
3 . This is also where you name and select the destination of your newly
scanned photos .
9