Remote Control Battery Installation; Remote Control Operation; Scanning - Brookstone iConvert User Manual

ReMoTe conTRol baTTeRY InsTallaTIon

1 . If the remote control is being used for the first time, remove the insulating
mylar strip from the battery compartment to allow contact .
2 . To replace the battery, press and hold the battery release tab in
the direction of arrow as shown in the diagram on the back of the
remote control .
3 . Pull out the battery holder completely .
4 . Remove the old battery .
5 . Place a new CR2025 battery in the battery tray, positive side up .
6 . Slide the battery holder back into the remote securely .

ReMoTe conTRol oPeRaTIon

Point the remote control at the unit from no more than 10 feet and within 60° of
the front of the unit . The operating distance may vary according to the brightness
of the room .
note: If the remote control unit fails to work, even when it is operated
near the player, replace the battery.

scannInG

photo protectIve Sleeve
Place smaller or damaged photos in the protective sleeve (included) to prevent damage .
Protective sleeve should also be used if photos are not feeding into the scanner straight .
Remove white cleaning cloth from inside the sleeve before use .
note: periodically run the white cleaning cloth through the scanner to clean.
11