Replacing A Defective Power Supply In The Galaxynaslx22 Chassis - Rorke Data GalaxyNASLX2 Configuration And System Integration Manual

G A L A X Y N A S L X C O N F I G U R A T I O N
4.3.3 Replacing a defective power supply in the GalaxyNASLX2 Chassis
Note: If a supply has failed, the system alarm will beep and the PSU Fault LED will
change to amber. In addition the failing supply's LED will turn RED to indicate the defective
supply. The power supply is 'HOT SWAPPABLE' and can be replaced without turning off
power to the GalaxyNASLX2.
Remove the power supply locking bar located on the left side of the supply area.
Disconnect the power cord from the defective supply
Squeeze the retaining clip on the right side of the supply and use the handle or clip to remove
the supply.
Install the new supply and reverse the above steps.
The supply should automatically become active and join the chassis power requirements. The
supply's LED turns GREEN
93
A N D S Y S T E M I N T E G R A T I O N G U I D E
Section 4 Maintenance