General Information And Operating Instructions - Amana A1200S Service

General Information and Operating Instructions

Service Access
Component servicing is done by lowering the back panel,
removing the control panel assembly, and component
module panel. Refer to the disassembly section for
specific components replacement and adjustment
procedures.
!
WARNING
All component mounting panels must be grounded to
the oven chassis before performing any
troubleshooting.
Serial Plate Location
Some models
Filter
Installation Instructions
1. Unpack the oven carefully and examine it for shipping
damage. If damage is evident, notify the local carrier
immediately and file a damage claim. Menumaster
assumes no liability for damage incurred in transit.
2. If the oven has been stored in an extremely cold area,
wait several hours before plugging the oven into an
outlet.
3. Remove all material from the oven interior.
4. Place the oven in the chosen location. Make sure
there is at least one inch of clearance on the top and
side and the air intake (filter) is not close to a high
temperature source. Example: A deep fat fryer.
5. The FS14EVP, FS16EVP, FS17, FS17EVP, FS20,
6. Plug the FS10 EVP, FSP10, FSP11, FSP11SS and
Important Electrical Grounding Instructions
This appliance must be grounded. In the event of an
electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the electric
current. This appliance is equipped with a cord having a
grounding wire with a grounding plug. The plug must be
plugged into an outlet that is properly installed and
grounded.
Improper use of the grounding plug can result in a risk
Some models
of electric shock.
Consult a qualified electrician or serviceman if the
grounding instructions are not completely understood, or if
doubt exists as to whether the appliance is properly
grounded.
If it is necessary to use an extension cord, use only a
three-wire extension cord that has a three-blade grounding
plug, and a three-slot receptacle that will accept the plug
on the appliance. The marked rating of the extension
cord shall be equal to or greater than the electrical rating
of the appliance.
7. Verify correct operation by performing system
11
FS20EVP oven must be adjusted to the proper supply
voltage. This oven is manufactured preset for 240
volts. If the supply voltage is less than 220 volts,
remove the small cover on the back of the oven and
move the voltage adjusting connector to the 208 volt
tap connector. Incorrect tap setting can cause
component damage.
VEND10 oven into a standard 120 volt outlet. Plug the
FS14 EVP, FS16EVP, FS17, FS17EVP, FS20,
FS20EVP into a 208 or 240 volt outlet. Be sure the
electrical outlet is rated for at least 20 amperes and
the microwave oven is the only appliance on the
circuit.
!
WARNING
diagnosis test.
RE220002 Rev. 6