Amana A1200S Service page 54

A1200S, A1225S Programming Instructions
!
NOTE: Opening the door during cooking will stop the
cooking and the Display Window will flash
"RESUME OR CANCEL". When the door is
closed, the oven will resume defrosting.
11. Close the door and the Display window will flash
"READY TO SCAN".
UPC Count Feature
This commercial microwave oven may be used to total the
number of heating cycles for each UPC since the oven
was put into operation.
1. Open door and leave open.
2. Enter "UPC Count" mode by pressing pads 6, 1, 2.
3. Close the door.
4. The display Window will show "COUNT" and then the
total number of heating cycles.
5. Scan each UPC you want to count. The control beeps
and displays count when UPC is accepted.
6. Open and close door to return to normal operation.
Tone Volume
Four separate volume settings are available for the audible
tone signalling the end of the cooking cycle - Off, Low,
Medium, and High. The factory preset volume is high.
Adjusting the volume
1. Place the removable keyboard onto the Scanner
Panel.
2. Open the door and leave open. Enter program entry
mode by pressing pads 6, 1, 6.
3. Close the door and the display will indicate on of the
following volume messages "OFF", "LOW",
"MEDIUM', or "HIGH".
4. To change volume to "OFF" press pad 1.
To change volume to "LOW" press pad 2.
To change volume to "MEDIUM" press pad 3.
To change volume to "HIGH" press pad 4.
5. Open and close the door to return to normal
operations.
RE220002 Rev. 6
WARNING
To avoid risk of electrical shock, personal injury, or death,
disconnect power to unit and discharge the capacitor
before following any disassembly procedures.
Clearing Display Window of Random Digits
NOTE: The four-position switch located on the back of
the circuit board must be activated before the
6, 1, 5 code will be accepted.
If the wrong pads are pressed when entering the
programming mode, a moving array of random digits
and letters may occur in the Display Window during
cooking and standby periods. Follow this procedure to
clear the Display Window of unwanted characters:
1. Open the door and leave open.
2. Press pads 6, 1, 5.
3. Close the door.
4. Press pad 1 until "00:2F" appears in the Display
Window.
5. Open and close door to return to normal operations.
54