Amana A1200S Service page 47

FS-10, 11, 14, 16 ,17, 20 Programming Instructions
!
Cook Count
To use the "Cook Count" feature:
1. Open the oven door, leave open.
2. Enter the access code "613" to enter the "Cook
Count" mode, push buttons 6, 1 and 3.
3. Close the oven door.
4. The oven display will show "C" for count and will
provide the total number of heating cycles for all ten
buttons combined. The left 4 digits will be displayed
for three seconds, followed by the right three digits.
Example:
"0045" for three seconds
"Blank" for two seconds
"817" for three seconds
NOTE: In this example, the total number of heating
cycles on all buttons is 45, 817.
5. Push each button to obtain the count for that specific
button.
Example:
Push button 4, note button 4 in the display.
Display shows left 3 digits for three seconds: "003".
Blank for two seconds.
Display shows right 3 digits for three seonds: "247".
The count for button 4 is 3,247 heating cycles.
6. After obtaining the counts, open the oven door to
exit the "Cook Count" mode or let the oven shut
itself down (in 60 seconds).
WARNING
To avoid risk of electrical shock, personal injury, or death,
disconnect power to unit and discharge the capacitor
before following any disassembly procedures.
47 RE220002 Rev. 6