Replacing The Access Panel - HP Integrity BL860c i2 Installation Manual
Server blade
Hide thumbs
Also See for Integrity BL860c i2:
- User's & service manual (157 pages) ,
- Quickspecs (35 pages) ,
- Safety and regulatory information manual (22 pages)
Table of Contents
Advertisement
1.
Remove the mezzanine connector cover.
2.
Align the mezzanine connector on the option card with the mezzanine connector on the
system board.
3.
Install the mezzanine card. Press down on the connector to seat the card:
CAUTION:
connector when installing the mezzanine card. Do not apply pressure to the edges of the
card.
NOTE:
The HP Smart Array P700m Controller requires additional procedures for installation.
Refer to the HP Integrity BL860c i2, BL870c i2 & BL890c i2 Server Blade User Service Guide for more
information.
Replacing the access panel
1.
Make sure the access panel latch is in the open position (pointing up).
To prevent damage to the server blade, apply pressure over the mezzanine
Installing additional components
31
Advertisement
Table of Contents
Need help?
Do you have a question about the Integrity BL860c i2 and is the answer not in the manual?
Questions and answers