Approved Kombiengines - Stihl KombiTool HT-KM 4182 Instruction Manual

English
Cutting above obstacles
The machine's long reach makes it
possible to prune branches that are
overhanging obstacles, such as rivers or
lakes. The tool angle in this case
depends on the position of the branch.
Cutting from a lift bucket
The machine's long reach enables
cutting to be performed next to the trunk
without the risk of the lift bucket
damaging other branches. The tool
angle in this case depends on the
position of the branch.
8
30° angle drive (special accessory)
1
2
The angle drive keeps the cutting
attachment at an angle of 30° to the
shaft.
The angle drive may be adjusted on the
shaft to the following positions only:
1 for cross-cutting vertical branches
and bushes
2 for a better view of the cutting
attachment

Approved KombiEngines

KombiEngines
Only use KombiEngines supplied or
explicitly approved by STIHL for use with
the attachment.
This KombiTool may be operated only in
combination with the following
KombiEngines:
STIHL KM 56 R, KM 85 R KM 94 R,
KM 111 R, KM 131 R, KMA 130 R
WARNING
Loop-handled machines must be
equipped with a barrier bar.
Brushcutters with split boom
The KombiTool can also be fitted to
STIHL brushcutters with a split shaft (T-
models) (basic power tools).
This KombiTool can therefore also be
used on the following machine:
STIHL FR 131 T
WARNING
Refer to the user manual of the power
tool for use of the barrier bar.
HT-KM