Polaroid Digital Microscope Camera Repair Manual page 45

DMC Repair Manual
6. Connect the 1-ohm resistor box 6 Vdc output cable to the camera power jack.
7. Connect the computer ribbon cable to the 1-ohm resistor box.
8. Turn on the test equipment as follows:
• Power Computing Power PC On/Off (0/1) switch to On (1).
• 0 - 10 Vdc external power supply On/Off switch to On. Adjust power supply output to
6 Vdc.
• Set the 1-ohm resistor box Manual/LV switch to LV (LabView).
• Set the Power Supply for DMC Pretest Target Fixture On/Off switch to On.
9. Turn on the camera as follows:
• If applicable, set the SCSI ID to 4.
• Set the Termination Selector to Off (0).
• Set Power Switch to On (0).
45
Testing & Adjustment