Table of Contents
Advertisement
DMC Repair Manual
Installation
1. Connect the back end board (male connector J3) to the front end board (female
connector J3).
2. Slide the electronics assembly into the top extrusion.
Notes:
•
Electronic assembly must slide in from the end furthest from the notch
on the base of the top extrusion.
•
Back end board slides into the channel of the the top extrusion.
•
Front end board rests above the supports of the top extrusion.
3. Connect the XSYNC connector to the back end board.
4. Install the rear panel and XSYNC assembly.
5. Install and tighten the four (4) screws and star washers that secures the electronics
assembly to the top extrusion supports:
6. Install the front panel and optics assembly.
7. Install the bottom extrusion.
33
Parts Replacement
Advertisement
Table of Contents
