Table of Contents
Advertisement
Main Menu
Setting the Time
Hold down C for about two
1.
seconds.
[Set Hold] will appear and
"hours" will flash.
a. Hours
b. Minutes
c. Seconds
Time Setting:
Each press of B moves
the flashing in the
following sequence:
"hour", "minute", "second".
Use D and A to change
the setting of the flashing
item.
Press C to end setting.
2.
Press B twice to return to the
3.
Timekeeping Mode.
Note
Setting "0H00'00"" can set a
100-hour countdown timer.
Setting the Time
Using the Timer
STB-1000
Operation Guide 3423
Main Menu
Using the Timer
a. Hours
b. Minutes
c. Seconds
d. 1/10 seconds
1.
Use the button operations below to
perform a countdown.
D
Start
Timer starts.
↓
D
Stop
Timer stops.
↓
D
Resume
Timer resumes.
↓
Time up (00:00)
Alert by beep or vibration.
To discontinue a timer operation part
way through,press D to stop it and then
press A to reset to the timer start time.
To stop a beep or vibration alert
operation, press any button or double-
tap the center of the watch's display.
Press B twice to return to the
2.
Timekeeping Mode.
Setting the Time
Using the Timer
Top of Page
Main Menu
Display Illumination
WORLDWIDE
A simple operation illuminates the
Manuals
display of the watch for easy
reading in the dark. You can also
STB-1000
enable an Auto Light feature that
illuminates the display whenever
you angle the watch towards
your face for viewing.
Main Menu
Illuminating the Display
Illuminating the Display
Enabling Auto Light
Top of Page
Press L in any mode to illuminate
the display.
Supplement
The display illumination will
turn off automatically if an
alarm alert, incoming call
alert, or any alert operation
starts while it is on.
Changing the Illumination
Duration
The illumination duration can be
set to two types: 1.5 seconds
and three seconds.
Press B to switch to the
1.
Timekeeping Mode.
See:
Mode Switching
Hold down C for about two
2.
seconds.
[SET Hold] will appear and
the time offset value will
flash.
Advertisement
Table of Contents
