Yamaha YZ250 Owner's Service Manual page 58

STARTING AND BREAK-IN
cC
9 After the break-in or before each race, you
must check the entire machine for loose fit-
tings and fasteners as per "TORQUE-
CHECK POINTS".
Tighten all such fasteners as required.
9 When any of the following parts have been
replaced, they must be broken in.
CYLINDER AND CRANKSHAFT:
About one hour of break-in operation is
necessary.
PISTON, RING AND GEARS:
These parts require about 30 minutes of
break-in operation at half-throttle or less.
Observe the condition of the engine careful-
ly during operation.
1-15
GEN
INFO