Initial Startup; Accessing The Menu - Raymarine RAY50 Installation And Operation Instructions Manual

6.6 Initial startup

Unless your radio has been pre-programmed;
the first time you power-up your radio you will
be requested to select certain options. With the
exception of your MMSI and ATIS ID, you will also be
requested to enter these options after a factory reset.
After acknowledging the startup screen, unless
previously set you will be prompted to make the
following selections:
1. Language selection
See 6.8 Selecting a language
languages.
2. Turn on AIS reception — Ray70 only
Enables the built-in AIS receiver. This step
is only applicable to radios with a built-in AIS
receiver. See 6.9 Switching on the AIS receiver
for more information.
3. Select network type
Selects which connection to transmit AIS and
DSC information to connected equipment on.
This step is only applicable if the AIS receiver
was turned on in the previous step. See
Selecting a network type
4. Enter MMSI number
Required to enable DSC functions. This option
is not required after a factory reset, or if the
radio has been pre-programed in MARCOM-C
mode, or has ATIS enabled. See
an MMSI number for more information. If not
already selected you will also be prompted to
select your network type.
5. Enter ATIS ID
Required when the radio will be used in the
inland waterways of Europe. This step is only
applicable if the radio has been pre-programed
in MARCOM-C mode. See
ATIS ID for more information.
6. Frequency band selection
Sets the relevant channels for your region. This
step is not applicable if the radio has been
pre-programed in MARCOM-C mode. See
Changing the radio region
48
for available
6.10
for available options.
6.11 Entering
6.13 Entering an
6.14
for more information.

6.7 Accessing the menu

The radio's various options and settings are
contained within the menu.
From the Homescreen.
1. Press the Rotary knob's OK push button.
D13228-1
Ray50 / Ray60 / Ray70