Ray60 / Ray70 Panel Mounting - Raymarine RAY50 Installation And Operation Instructions Manual

5.3 Ray60 / Ray70 Panel mounting

Drilling out the mounting holes – Ray60 /
Ray70
Before panel mounting the product the mounting
holes must be drilled out.
Guides for the mounting holes can be found in the
corners of the unit, under the front bezel.
1. Using a drill and a 4 mm (5/32) drill bit, drill out
the 4 mounting holes.
Holes should be drilled from the front of the unit,
taking care not to damage the unit by applying
too much force to the drill.
Panel mounting – Ray60 / Ray70
To panel mount the Ray60 / Ray70 follow the steps
below.
Before mounting the product, ensure that you have:
• Selected a suitable location, ensuring there is
nothing behind the mounting surface that may be
damaged when drilling / cutting.
• Identified the cable connections and route that the
cables will take.
• Drilled out the mounting holes on the unit.
• Removed the front bezel.
1. Check the selected location for the unit. A clear,
flat area with suitable clearance behind the panel
is required.
2. Fix the supplied mounting template to the
selected location, using masking or self-adhesive
tape.
40
3. Using a suitable hole saw (the size is indicated
on the template), make a hole in each corner of
the cut-out area.
4. Using a suitable saw, cut along the inside edge
of the cut-out line.
5. Ensure that the unit fits into the removed area
and then file around the rough edge until smooth.
6. Drill 4 holes as indicated on the template to
accept the fixings.
7. Remove the backings from the supplied gasket.
8. Place the gasket in position on the back of the
unit and press firmly onto the flange.
9. Connect the power, and other cables to the unit.
10. Slide the unit into place and secure using the
fixings provided.
11. Attach the front bezel.
Note: The supplied gasket provides a seal
between the unit and a suitably flat and stiff
mounting surface or binnacle. The gasket should
D13209-1
always be used. It may also be necessary to use
a marine-grade sealant if the mounting surface or
binnacle is not entirely flat and stiff or has a rough
surface finish.
Attaching the front bezel – Ray60 / Ray70
After installation the front bezel can be attached
following the steps below.
The following procedure assumes that the unit has
already been mounted in position.
1. Orientate the bottom-right side of the bezel under
the bottom-right side of the unit, ensuring that the
clips along the bottom edge of the bezel latch
into position.
2. Ensure the bezel is correctly aligned with the unit,
as shown.
3. Apply firm but even pressure to the bezel along
the:
i. Outer edges - work from the sides upwards
D13210-1
and then along the top edge, to ensure that it
clips securely into position.
ii. Inner edges - ensure that the bezel sits flat.
4. Check that all control buttons are free to operate.
D1321 1-1
Ray50 / Ray60 / Ray70