Raymarine ray50 Mounting And Getting Started
Hide thumbs
Also See for ray50:
- Installation and operation instructions manual (116 pages) ,
- Mounting and getting started (24 pages) ,
- Troubleshooting manual (60 pages)
Subscribe to Our Youtube Channel
Related Manuals for Raymarine ray50
Summary of Contents for Raymarine ray50
- Page 1 Ray50 / Ray52 / Ray60 / Ray70 Mounting and Getting Started Da te : 01-2016 Docume nt numbe r: 88033-3-EN © 2016 Ra yma rine UK Limite d...
- Page 2 Da te : 01-2016...
-
Page 3: Making A Distress Call
2. Press and hold the PTT button. • Raymarine recommends certified 3. Slowly and clearly speak the details of the distress: installation by a Raymarine approved 55 60 5 installer. A certified installation qualifies MAYDAY, MAYDAY, MAYDAY for enhanced product warranty benefits. -
Page 4: Water Ingress
Raymarine will not warrant products subjected to high-pressure washing. Ray52 / Ray50 / Ray60 / Ray70... - Page 5 Ships that use MF/HF single side-band radio, satellite circuit different from that to which the receiver is communications, or telegraphy must be licensed by the Raymarine does not warrant that this product is connected. FCC. You can obtain a Station License by filing FCC...
-
Page 6: Emc Installation Guidelines
FCC Type accepted Parts 2, 15 and 80 Your product includes ATIS functionality for use on the • Raymarine equipment and cables connected to it are: inland waterways of contracting governments of the Output power 1 watt (low) and 25 watt (high) “Regional Arrangement on the Radiocommunication... -
Page 7: Applicable Products
(IMO) and Safety of Life at Sea (SOLAS) Carriage Requirement for ferrites on non-Raymarine cables Regulations. If your Raymarine equipment is to be connected to other equipment using a cable not supplied by Raymarine, a Technical accuracy suppression ferrite MUST always be attached to the To the best of our knowledge, the information in this cable near the Raymarine unit. -
Page 8: Location And Mounting
3.5 metres (11.5 ft) above the below decks will be more susceptible to performance main deck to meet the MPE for persons up to 2 metres issues related to the prevailing conditions. Ray52 / Ray50 / Ray60 / Ray70... -
Page 9: Mounting Options
Ray50 / Ray52 product dimensions vessel’s DC power supply. This will help to keep cable • Ensure that equipment is mounted in a compartment The Ray50 / Ray52 can be panel mounted or bracket runs to a minimum. of suitable size. -
Page 10: Bracket Mounting
Note: Drill bit, tap size and tightening torque is dependent on the thickness and type of material the unit is to be mounted on. 25 mm (1 in . ) 204.6 mm (8 in .) D13171-1 Ray52 / Ray50 / Ray60 / Ray70... - Page 11 Ray52 the fixings. Panel mounting – Ray50 / Ray52 Before the Ray50 / Ray52 can be panel mounted the 7. Remove the backings from the supplied gasket. mounting hole covers must be removed. To panel mount the Ray50 / Ray52, follow the steps below.
- Page 12 11. Attach the front bezel. ii. Inner edges - ensure that the bezel sits flat. 4. Check that all control buttons are free to operate. Ray52 / Ray50 / Ray60 / Ray70...
-
Page 13: Power Connection
The example illustrations provided are for common vessel power arrangements, if you are unsure how to provide the correct level of protection D13214-1 then please consult a Raymarine authorized dealer for 1. Base station support. 2. Passive speaker connection. - Page 14 2. Fully insert the connector into the connector on the 4. Product power cable Positive (+) bar front of the unit. 5. Vessel battery 3. Rotate the locking collar clockwise until it clicks. Negative (-) bar Ray52 / Ray50 / Ray60 / Ray70...
- Page 15 Yellow – Receive positive Transmit positive (+) SeaTalk D13293-1 Green – Receive negative Transmit negative (-) 1. Ray50 / Ray52 / Ray60 / Ray70 D13218-1 2. Optional Raymic handset station (Ray70 and 1. Rotate the SeaTalk ng® connector’s locking collar Ray70 only) White –...
-
Page 16: Controls And Interface
The startup screen will automatically time-out after 5 seconds. 2. Press the OK button, or wait for the startup screen to time-out. D13221-1 Ray52 / Ray50 / Ray60 / Ray70... -
Page 17: Powering The Unit Off
Status bar symbols The Homescreen is displayed. 3. Status text — Indicates the current radio mode e.g.: ATIS Mode active, Weather Alert, Scan mode The status bar is used to display icons that indicate the etc. radio’s status. Powering the unit off 4. - Page 18 • All channels + 16 • Network output DSC Calls • Saved channels • ATIS set-up atch M ode • Saved channels + • Maintenance W eather M ode • Edit saved channels D13223-1 Ray52 / Ray50 / Ray60 / Ray70...
-
Page 19: Shortcut List
Initial startup Accessing the menu Note: * Menu items not available when radio has ATIS The radio’s various options and settings are contained Unless your radio has been pre-programmed; the first enabled or if the radio has been pre-programed in within the menu. - Page 20 NMEA 0183 High Speed High speed (38400) From the Main menu. Move cursor back and forward through the digits. 1. Select Set-up. NMEA 0183 Standard Speed Standard speed (4800) 2. Select ATIS set-up. Ray52 / Ray50 / Ray60 / Ray70...
-
Page 21: Entering Your Atis Id
5. To enter your ATIS ID manually, use the Rotary ATIS ID in your product, it will have to be • DSC functions knob to cycle through the available numbers and reset by an authorized Raymarine ® dealer. press OK to confirm each number and move to the •... -
Page 22: Cancelling A Distress Call After Transmission
MMSI number and cancel the false This is <state name of vessel 3 times> distress alert To cancel a distress call before it is transmitted follow MAYDAY <state name of vessel 1 time> the steps below: Ray52 / Ray50 / Ray60 / Ray70... -
Page 23: Acknowledging A Distress Call
Phonebook, or you know a message has been received. When 2. Select Recent Calls to make a routine call to a connected to a Raymarine ® multifunction display contact that you have called recently, or (MFD) the position data from the distress call can also 3. - Page 24 Ray52 / Ray50 / Ray60 / Ray70...
- Page 26 (Ray50 / Ray60 / Ray70) (Ray52) www.raymarine.com...
Need help?
Do you have a question about the ray50 and is the answer not in the manual?
Questions and answers