Panasonic KX-NCP1000 Programming Manual page 15

When not using a DHCP server to obtain a DNS server IP address automatically:
a.
Select Manual for the DNS Server Address Method setting.
b.
In the Manual Preferred DNS Server IP Address box, type the IP address of the preferred DNS
server.
c.
In the Manual Alternate DNS Server IP Address box, type the IP address of the alternate DNS
server.
d.
Click Apply.
The system menu appears. You may now begin programming the PBX.
Notice
•
Do not change the IP addresses of the IPCMPR and DSP cards once IP telephones are
registered to the PBX using these IP addresses.
The IP telephones will not operate properly if these IP addresses are changed.
•
A DHCP server must be able to use a "client identifier" option specified by RFC 2131.
•
The PBX will not start properly if the IP addresses cannot be assigned automatically by the
DHCP server when DHCP Client is set to Enable. In this case, you need to consult your
network administrator because the DHCP server on your network may not be running or a
network failure may have occurred. If the DHCP server cannot be available, change the
DHCP Client setting to Disable and set fixed IP addresses, then restart the PBX.
To change the DHCP Client setting, connect the PC with an RS-232C cross cable or Ethernet
straight cable. When connecting the PC with an Ethernet straight cable, make sure the PBX
is disconnected from the LAN and then connect the PC with an Ethernet straight cable using
192.168.0.101 for the IP address of the IPCMPR card.
*1 Valid IP address range: "1.0.0.0" to "223.255.255.255"
*2 Valid IP address range: "1.0.0.0" to "223.255.255.255"
Valid subnet mask address range: "0–255.0–255.0–255.0–255" (except 0.0.0.0 and 255.255.255.255)
*3
*4 Valid IP address range: "1.0.0.0" to "223.255.255.255"
Document Version 2009-12
2.1.1 Installing and Starting the Maintenance Console
Programming Manual for Virtual SIP CO Line Card 15