TP-Link Archer C50 User Manual page 40

Connect Manually - You can click the Connect/Disconnect button to connect/disconnect

immediately. This mode also supports the Max Idle Time function as Connect on Demand
mode. The Internet connection can be disconnected automatically after a specified inactivity
period and re-established when you attempt to access the Internet again.
Click the Connect button to connect immediately. Click the Disconnect button to disconnect
immediately.
Caution: Sometimes the connection cannot be terminated although you specify a time to Max Idle
Time because some applications are visiting the Internet continually in the background.
If you want to do some advanced configurations, please click the Advanced button, and the page
shown in Figure 4-6 will then appear:
Service Name/Server Name - The service name and server name should not be configured

unless you are sure it is necessary for your ISP. In most cases, leaving these fields blank will
work.
MTU(Bytes) - The default MTU size is "1480" bytes, which is usually fine. It is not

recommended that you change the default MTU Size unless required by your ISP.
Enable IGMP Proxy - IGMP (Internet Group Management Protocol) is used to manage

multicasting on TCP/IP networks. Some ISPs use IGMP to perform remote configuration for
client devices, such as the modem router. The default value is enabled, and if you are not
sure, please contact your ISP or just leave it.
 Use IP address specified by ISP - If your ISP does not automatically assign IP addresses to
the router during login, please click "Use IP address specified by ISP" check box and enter
the IP address provided by your ISP in dotted-decimal notation.
Echo request interval - The router will detect Access Concentrator online at every interval.

The default value is "0". You can input the value between "0" and "120". The value "0" means
no detect.
Archer C50
Figure 4-6 PPPoE Advanced Settings
- 29 -
AC1200 Wireless Dual Band Router