TP-Link Archer C50 User Manual page 121

1) Dynamic IPv6
 IPv6 Address - The IPv6 address assigned by your ISP dynamically.
Prefix Length - The length of IPv6 address prefix.

 IPv6 Gateway - Enter the default gateway provided by your ISP.
 Addressing Type - There are two types of assignation for IPv6 address: SLAAC (Stateless
address auto-configuration) and DHCPv6 (Dynamic Host Configuration Protocol for IPv6)
Server.
 MTU(Bytes) - The normal MTU (Maximum Transmission Unit) value for most Ethernet
networks is 1500 Bytes. For some ISPs, you may need to modify the MTU. But this is rarely
required, and should not be done unless you are sure it is necessary for your ISP connection.
If your ISP gives you one or two DNS IPv6 addresses, select Set IPv6 DNS Server manually and
enter the IPv6 DNS Server and Secondary IPv6 DNS Server into the correct fields. Otherwise,
the DNS servers will be assigned from ISP dynamically.
 Enable MLD Proxy - Enable the Multicast Listener Discovery (MLD) Proxy function if you need.
 IPv6 DNS Server - Enter the DNS IPv6 address provided by your ISP.
 Secondary IPv6 DNS Server - Enter another DNS IPv6 address provided by your ISP.

Note:
If you get Address not found error when you access a Web site, it is likely that your DNS servers
are set up improperly. You should contact your ISP to get DNS server addresses.
Archer C50
Figure 4-103 Dynamic IPv6
- 110 -
AC1200 Wireless Dual Band Router