TP-Link Archer C50 User Manual page 29

2.4GHz - You can use the 2.4GHz band to connect to many classic wireless devices like

gaming consoles, laptops, DVRs, etc.
5GHz - This band is less crowded and is used for time-sensitive music, video streaming

or gaming. Using this band can avoid interference with 2.4GHz networks or noisy
devices like cordless phones and microwave ovens.
6. Configure the basic parameters for 2.4GHz wireless network in the following screen as
shown in Figure 3-13, and then click Next.
Wireless Network Name - Also called the SSID (Service Set Identification). Enter a

value of up to 32 characters. The same name must be assigned to all wireless devices
in your network. The default SSID is set to be TP-LINK_XXXX. This value is
case-sensitive. For example, TEST is NOT the same as test.
Region - Select your region from the drop-down list. This field specifies the region

where the wireless function of the router can be used. It may be illegal to use the
wireless function of the router in a region other than one of those specified in this field. If
Archer C50
Figure 3-12 Quick Setup – Dual Band Selection
Figure 3-13 Quick Setup – Wireless 2.4GHz
AC1200 Wireless Dual Band Router
- 18 -