Setting Menus; Naming Of Transmitter (Name); Selecting The Frequency Band (Band) - Sony DWT-P01 Operating Instructions Manual

Setting Menus

The functions and parameters of the settings
menu are explained here. Underlined items
are the factory setting.
Naming of transmitter
(NAME)
You can specify a transmitter name of up to
16 characters. The factory setting for the
transmitter name is the model name and
serial number. The transmitter name is sent
to the receiver as metadata and is used by
the receiver to distinguish between different
transmitters.
+: The first press on the + button displays
the character set. You can then use the + and
– buttons to select the desired character.
And then, pressing the SET button adds the
selected character to the end of the current
name.
– : Deletes the last character in the current
name.
SET: Enters the character or edited name.
Note
You cannot insert or delete a character in
the middle of the name.
Using wireless remote control, this function
can be controlled from the receiver and
other devices.
For details on wireless remote control function, see
"Using the Cross Remote" on page 14.
20 Setting Menus
To edit with a keyboard
You can enter data from an optional
keyboard connected to the USB connector.
For details, see "Using a USB Keyboard" on
page 18.
Selecting the frequency
band
(BAND)
Match the frequency range on this
transmitter to that of the Sony digital
wireless receiver.
See "Carrier Frequencies and Channel
Steps" on page 31 for differences in
frequency ranges that can be set for optional
receivers combined with this transmitter.
For details on the frequency range of each band,
refer to "Sony Digital Wireless Microphone System
Frequency Lists" on the supplied CD-ROM.
Using wireless remote control, this function
can be controlled from the receiver and
other devices.
For details on wireless remote control function, see
"Using the Cross Remote" on page 14.
Notes
• The setting for this function cannot be
changed during actual signal
transmission. To change the setting, turn
off the transmitter first. Then, while
holding down the SET button, turn the
power on. Then change the setting after
the signal transmission has stopped.
• Be sure to select the group/channel right
after selecting the frequency band. To
start signal transmission with the selected
frequency band/group/channel, turn off
the power and then turn it on again.