Basic Menu Operations; Setting Menus; Unit Name Setting (Name); Selecting The Frequency Band (Band) - Sony DWT-P30 Operating Instructions Manual

Basic Menu Operations

Function name
Item to be set
1
Press the + or – button repeatedly until the function to
be set appears.
Holding down the + and – buttons allows you to cycle
through screens quickly.
In addition, holding down the + button while the first
setting item of the menu is displayed allows you to
jump to the last setting item, while holding down the
– button while the last setting item of the menu is
displayed allows you to jump to the first setting item.
2
Hold down the SET button until the item to be set
flashes.
3
Press the + or – button to change the setting.
4
Press the SET button to enter the setting.
Setting items in the menu
• NAME (transmitter name) setting
• BAND (frequency band) selection
• GP/CH (group/channel) selection
• AF ATT (audio attenuator level) setting
• LCF (low-cut filter) setting
• LOCK function
• POWER SAVE setting
• BATTERY TYPE (battery type) setting
• RF REMOTE (wireless remote control) function
• SEARCH RX (receiver search) function
• CODEC MODE (audio codec mode) setting
• ENCRYPTION (encrypted transmission function)
setting
• INPUT LEVEL (audio input level) setting
• +48V (+48 V power supply) setting
• AF PHASE (audio phase switch) setting
• INTERNAL SG (internal signal generator) function
• RF POWER (RF transmission power) setting
• MAX RF POWER (maximum RF transmission power)
setting
• TIME (accumulated use time) indication
• BRIGHTNESS (display brightness) setting
• DIMMER MODE (automatic display dimmer) setting
• USER MEMORY (settings storage) function
• POWER PRIORITY (power source priority) setting
• FACTORY PRESET (factory settings) function
• VERSION (software version) display

Setting Menus

The functions and parameters of the settings menu are
explained here. Underlined items are the factory setting.
Unit name setting
You can specify a transmitter name of up to 16 characters.
The factory setting for the transmitter name is the model
name and serial number. The transmitter name is sent to
the receiver as metadata and is used by the receiver to
distinguish between different transmitters.
+: The first press on the + button displays the character set.
You can then use the + and – buttons to select the desired
character. And then, pressing the SET button adds the
selected character to the end of the current name.
– : Deletes the last character in the current name.
SET: Enters the character or edited name.
Note
You cannot insert or delete a character in the middle of the
name.
Using wireless remote control, this function can be
controlled from the receiver and other devices.
For details on wireless remote control function, see
"Using Cross Remote" (page 8).
Selecting the frequency band
Match the frequency range on this transmitter to that of the
Sony digital wireless receiver.
See "Carrier Frequencies and Channel Steps" (page 20)
for differences in frequency ranges that can be set for
optional receivers combined with this transmitter.
For details on groups and channels included in each
frequency band, refer to the frequency lists.
Using wireless remote control, this function can be
controlled from the receiver and other devices.
For details on wireless remote control function, see
"Using Cross Remote" (page 8).
Notes
• The setting for this function cannot be changed during
actual signal transmission. To change the setting, turn
off the transmitter first. Then, while holding down the
SET button, turn the power on. Then change the setting
after the signal transmission has stopped.
• Be sure to select the group/channel right after selecting
the frequency band. To start signal transmission with the
selected frequency band/group/channel, turn off the
power and then turn it on again.
10
(NAME)
(BAND)