Basic Menu Operations; Setting Menus; Naming Of Transmitter (Name); Selecting The Frequency Band (Band) - Sony DWT-B01N Operating Instructions Manual

Basic Menu Operations

Function name
Item to be set
1
Press the + or – button repeatedly until the function to
be set appears.
2
Hold down the SET button until the item to be set
flashes.
3
Press the + or – button to change the setting.
4
Press the SET button to enter the setting.
Types of menu:
• NAME (transmitter name) setting
• BAND (frequency band) selection
• GP/CH (group/channel) selection
• RF POWER (RF transmission power) setting
• INPUT LEVEL (audio input level) setting
• LCF (low-cut filter) setting
• POWER SAVE setting
• BATTERY TYPE (battery type) setting
• TIME (accumulated use time) indication
• ENCRYPTION (encrypted transmission function)
setting
• CODEC MODE (audio codec mode) setting
• MAX RF POWER (maximum RF output power) setting
• INTERNAL SG (internal signal generator) function
• POWER SW LOCK (POWER switch lock) function
• RF REMOTE (wireless remote control) function
• BRIGHTNESS (display brightness) setting
• DIMMER MODE (automatic dimming of the display)
setting
• FACTORY PRESET (factory setting) function
• VERSION (software version) indication

Setting Menus

The functions and parameters of the settings menu are
explained here. Underlined items are the factory setting.
Naming of transmitter
You can specify a transmitter name of up to 16 characters.
The factory setting for the transmitter name is the model
name and serial number. The transmitter name is sent to
the receiver as metadata and is used by the receiver to
distinguish between different transmitters.
+: The first press on the + button displays the character set.
You can then use the + and – buttons to select the desired
character. And then, pressing the SET button adds the
selected character to the end of the current name.
– : Deletes the last character in the current name.
SET: Enters the character or edited name.
Note
You cannot insert or delete a character in the middle of the
name.
Using wireless remote control, this function can be
controlled from the receiver and other devices.
For details on wireless remote control function, see
"Using the Cross Remote" on page 7.
To edit with a keyboard
You can enter data from an optional keyboard connected to
the USB connector.
For details, see "Using a USB Keyboard" on page 9.
Selecting the frequency band
Match the frequency range on this transmitter to that of the
Sony digital wireless receiver.
See "Carrier Frequencies and Channel Steps" on page 20
for differences in frequency ranges that can be set for
optional receivers combined with this transmitter.
For details about the frequency range of each band, refer
to "Sony Digital Wireless Microphone System Frequency
Lists" on the supplied CD-ROM.
Using wireless remote control, this function can be
controlled from the receiver and other devices.
For details on wireless remote control function, see
"Using the Cross Remote" on page 7.
Notes
• The setting for this function cannot be changed during
actual signal transmission. To change the setting, turn
10
(NAME)
(BAND)