Cross Remote (Rf Remote); Setting The Brightness Of The Display (Brightness); Automatic Dimming Of The Display (Dimmer Mode); Resetting Parameters To Their Factory Settings (Factory Preset) - Sony DWT-P01 Operating Instructions Manual

For details on wireless remote control function, see
"Using the Cross Remote" on page 14.
Cross Remote
This function must be set to allow the
wireless remote control function to be used
between the transmitter and receiver.
OFF: Stops the wireless remote control
function.
ON: Starts the wireless remote control
function with the previously paired
receiver.
PAIRING: Executes a new pairing.
For details, see "Pairing with a receiver" on
page 14.
Note
If "RESTRICTED BY GP/CH SETTING"
appears on the RF REMOTE screen, the
wireless remote control function cannot be
used. To use the wireless remote control
function, select a different transmission
channel.
For details on how to change the transmission
channel, see "Setting the Transmission Channel" on
page 12.
Setting the brightness of
the display
Ten levels of brightness can be selected for
the organic light-emitting diode display.
The selectable settings are the following:
(Dark) 1 2 3 4 5 6 7 8 9 10 (Bright)
Automatic dimming of the
display
(DIMMER MODE)
The organic light-emitting diode display
can be set to dim or turn off after a certain
amount of time.
24 Setting Menus
(RF REMOTE)
(BRIGHTNESS)
AUTO OFF: The display turns off after 30
seconds. The display goes on again when
you press the SET, +, or – button.
AUTO DIMMER: The display dims after
30 seconds. The display becomes bright
again when you press the SET, +, or –
button.
ALWAYS ON: The display stays on at the
brightness level set with the BRIGHTNESS
function.
Resetting parameters to
their factory settings
(FACTORY PRESET)
All parameter settings can be returned to
their factory settings.
Holding down the SET button until a
message appears asking for confirmation.
Press the + or – button repeatedly to select
YES, and then press the SET button to
enter. The transmitter parameters are reset
to their factory settings.
Notes
• The setting for this function cannot be
changed during actual signal
transmission. To change the setting, turn
off the power first. Then while holding
down the SET button, turn the power on.
Then change the setting after the signal
transmission has stopped.
• To start signal transmission with the
factory parameter settings, turn off the
power and then turn it on again.
Displaying the software
version
(VERSION)
The version of the transmitter software can
be displayed.