Mitel 6865i User Manual page 110

Mitel 6865i SIP Phone Release 4.1.0 User Guide
6. Click Save Settings.
Expansion Module Keys
7. Select from Key 1 through Key 16 (M680i) or Key 84 (M685i).
8. In the Type field, select Paging.
9. In the Value field, enter a multicast IP address and a port number for the Paging key. When
you press this key, the phone initiates an outgoing multicast RTP session to the specified
address using the specified port. (For example, 239.0.1.15:10000).
Notes:
1. When you select Paging for the Type field, the Line field is disabled.
2. The Value field allows for one multicast address entry only.
3. To receive RTP steams for Group Paging, you must also configure the Paging
10. Click Save Settings to save your changes
USING THE PAGING KEY
The following procedure describes the use of the Paging key on the IP phone. The procedure
assumes you have already configured the Paging key using the Mitel Web UI.
Notes:
1. The recipient of a Paging call can set a global Do Not Disturb (DND) to ignore any
incoming pages.
2. For incoming Paging, the phone uses the Intercom configuration settings. The
incoming Page is dependant on the Allow Barge In parameter setting and the
Idling/On Call state.
IP PHONE UI
1. On the IP phone, press the key you configured for Paging.
The phone opens a multicast RTP session and an outgoing OR incoming phone screen
displays.
2. Press the Drop key to end the multicast RTP session and return to the idle screen.
Note: If you enable global DND on the phone, the incoming multicast RTP session is
dropped.
108
Listen Addresses parameter at the path, Basic Settings > Preferences > Group
Paging RTP Settings. For more information about setting this parameter, see
"Group RTP Paging" on page 172.