Installation - Datalogic Magellan 3200VSI Quick Reference Manual

Installation

Connect the scanner to the host (terminal) using the interface (I/F) cable
as shown below. A cable from an older existing installation can be re-
used if it uses Power Off the Terminal (POT), unless it is a USB POT cable.
If external power is used/needed, plug the AC Adapter into the AC wall
outlet, then connect it to the I/F cable as shown in 'b' and 'c' of the illus-
tration.
Scan some known-good bar code samples to verify correct operation. The
scanner should beep and/or flash its good read LED
code data to the host or terminal. If not, use the Troubleshooting section
of this guide to identify any problems.
Scanner installation is complete.
a
Power Off
the Terminal
(POT)
b
c
1. Be aware that beeper and LED behavior may have previously been config-
ured as "disabled" by another user.
2
Terminal (PC)
or...
or...
Keyboard Wedge, RS-232
and USB Cables
Powered by AC Adapter
To Terminal (PC)
Other Non-POT Cables
Powered by AC Adapter
via short adapter cable
To Terminal (PC)
1
and send the bar
Keyboard
Wedge
TM
Magellan 3200VSi