Error Codes
If an error is detected, the scanner will sound a long low tone (for three
seconds) and flash its LED, indicating a failure. When this occurs, press
the Scanner Push button to hear the error code. If it is configured to do
so, the scanner will sound a series of beeps corresponding to the error
code and/or flash its LED simultaneous to the beeps. The table below
describes what these codes mean and what action should be taken for
each.
NUMBER OF
LED FLASHES/
BEEPS
1
2
4
6
10
11
12
13
8
ERROR
Configuration
Interface PCB
Imager
Main PCB
Button Error
Hardware ID
Model ID
CPLD ID
CORRECTIVE ACTION
Contact Helpdesk for
assistance
Magellan
TM
3200VSi