Datalogic Magellan 3200VSI Quick Reference Manual page 7

Table 1. Scanner Push Button Functions
PRESS
DURATION
Momentary
(when scanner is
asleep)
Momentary
(when scanner is
awake)
Hold, then
release when the
beeper sounds
4 Seconds
8 Seconds
a. By standard default, this function is normally disabled to prevent
accidental activation by users.
b. Users should not perform scanner resets except under the direction
of trained systems support personnel.
Quick Reference Guide
FUNCTION
Wakes scanner from
Sleep Mode
Increments volume
Increments tone
Scanner Diagnostics
a
Mode
b
Resets Scanner
COMMENT
Alternatively, the scanner can
be awakened by:
- Moving an object through the
scan zone.
- Scanning with an attached
auxiliary scanner.
Press the push button momen-
tarily to increase speaker vol-
ume. When the loudest volume
is reached, a repeated press of
the push button cycles volume
back to the lowest setting, then
volume increases on subse-
quent press(es). Four volume
levels are available.
Press the push button for
approximately 2 seconds, then
release. Each time this is done,
the beeper will sound at one of
three tones. Stop when the
desired tone (high, medium or
low) is sounded.
This mode allows system sup-
port personnel to troubleshoot
problems with the scanner and
is used to determine if it can
read bar codes. Press the but-
ton for 8 seconds or cycle
power to exit Scanner Diagnos-
tics Mode and reset the scan-
ner.
Only system support person-
nel should perform a reset.
5