Heat & Glo VRT-BZ-N-AUB Owner's Manual page 59

FCC Requirements
WARNING! Risk of Fire! Changes or modifications to this
unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the
equipment.
Note: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules and EN298 for
multi-functional control. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee
that interference will not occur in a particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Contact the dealer or an experienced radio TV
technician for help.
Changing Temperature Scale
To change the temperature display between Celsius and
Fahrenheit, remove the battery cover from the back of
the remote control and slide the switch to your desired
temperature scale (see Figure 12.4). The screen will
automatically change the indicators on the room temperature
and set temperature portion.
Figure 12.4 Temperature Scale
59
Installation of Remote Control Housing
CAUTION! Risk of Fire! DO NOT install damaged or
modified components
or modified components are installed.
1. Remove remote control components from packaging.
2. Remove battery cover from the back of the remote by
To prevent unintended operation when not using your
fireplace for an extended period of time (summer months,
vacation, trips, etc):
3. Secure the remote control housing on a flat wall surface
Figure 12.5 Mounting Remote Control Housing
4. Place remote control inside housing. See Figure 12.6.
Figure 12.6 Remote in Housing
Heat & Glo • VRT-AUB • 2123-980_R14 • 12/14
Warranty will be voided if damaged
.
sliding it down and install 3 AAA batteries.
• Remove batteries from remote control.
• Unplug switching adapter and remove back-up batteries.
using the two screws and wall anchors provided. See
Figure 12.5.