Appliance Setup; Remove Shipping Materials; Unbolting Appliance From The Pallet; Leveling And Bolting Down The Appliance - Heat & Glo VRT-BZ-N-AUB Owner's Manual

9

Appliance Setup

A. Remove Shipping Materials
Remove shipping materials from inside or underneath the
firebox.
The gas line is shipped inside back panel. To access the
gas line remove the top plate from the gas stove. Remove
and retain the two Allen head screws that hold the back
panel in place. Replace panel when finished.
ALLEN HEAD SCREWS
Figure 9.1
B. Unbolting Appliance from the Pallet
The gas stove is bolted and screwed to the pallet for
shipping. Use a 1/2 in. (12.7) socket to remove the bolt in
center of bottom plate. Use a Phillips screwdriver to remove
the two screws in the front of the bottom plate and the two
screws holding the metal strap across the back of the gas
stove. Refer to Figure 9.2 for locations.
Figure 9.2
40
C. Leveling and Bolting Down the Appliance
SECURING THE GAS STOVE IS REQUIRED.
Figure 9.3
After unbolting the gas stove from the pallet, insert two 1/4
in.- 20 x 1-1/2 in. (6.3 mm - 20 x 38 mm) (or equivalent)
counterscrews.
Using pliers, adjust the counterscrews to level the gas stove.
Heat & Glo • VRT-AUB • 2123-980_R14 • 12/14
!
WARNING
Fire Risk.
Odor Risk.
Tipping Risk
• Install gas stove on a stable, level platform/
floor strong enough to support gas stove
without tipping.
• USE wood flooring, ceramic tile, brick hearth
or high pressure laminate flooring applied
directly over the sub-flooring material.
LEVELING
SCREWS