Installation Precautions - Heat & Glo VRT-BZ-N-AUB Owner's Manual

Hearth & Home Technologies disclaims any responsibility for,
and the warranty will be voided by, the following actions:
• Installation and use of any damaged system component.
• Modification of the system component.
• Installation other than as instructed by Hearth & Home
Technologies.
• Installation and/or use of any component part not approved
by Hearth & Home Technologies.
Any such action may cause a fire hazard.
• Read, understand and follow these instructions for safe
installation and operation.
Fireplace Specific Information
Standard fireplace features vary. Consult the installation
manual for available options.
The AUx300CE receiver provides additional features: Fan
control and two Aux functions.
The REM300-HNG-AU remote control system functions
include: On/Off, Thermostat Mode, Timer Countdown, and
Flame Adjustment (for fireplaces with variable flame).
Kit Contents
REM300-HNG-AU
• RC300-HNG-AU Transmitter
• AAA Batteries (3)
• Wall Holder
• Drywall Anchor (2)
• Screws (2)
58
Introduction
The RC300AU multifunctional remote control is designed
to control pilot light, flame height, blower speed, and up to
two 220-240 VAC auxiliary functions on your gas fireplace.
The RC300AU is equipped with thermostat functions
which can automatically control the temperature in the
room in which it is installed. The control is only for use
with the Hearth & Home Technologies IntelliFire Plus™
system (IPI). The AUX300CE module is rated for 220-240
VAC, 50-60 Hz, and is required for operation of this remote
control device.

Installation Precautions

The installation of this remote control must be performed
by a qualified service technician. This remote control is
tested and safe when installed in accordance with this
installation manual. Do not install any components that may
be damaged.
Do not modify, disassemble, or substitute any of the
components included with this kit. Installation of this unit
must be done by a qualified service technician.
Placement of this remote control may affect performance. An
assessment of the space should be done prior to installation
for optimum performance.
Determine Location
Determine the location for the remote control. The selected
location should be in the same space as the gas fireplace.
Never place this unit in a separate room. The remote control
must be placed within 30 ft. (914 mm) of the fireplace but
should not be exposed to extreme heat.
The RC300AU is approved for interior installation and should
not be used in exterior applications.
• Keep remote control out of reach of children.
Heat & Glo • VRT-AUB • 2123-980_R14 • 12/14