Adjusting The Height Of The Remote (Only For Swing-Away Remote Holders); Swivelling The Remote To The Side; Adjustment Options For The Modulite Seat Unit; Adjusting The Height Of The Armrests - Invacare TDX SP2 series User Manual

Invacare® TDX SP2® Series
5.2.2 Adjusting the height of the remote (only for
swing–away remote holders)
Requirements:
•
1 x 6 mm Allen key
Loosen the Allen screw A.
1.
2. Adjust the remote to the desired height.
3. Re-tighten the Allen screw.

5.2.3 Swivelling the remote to the side

If your mobility device is fitted with a swing-away remote holder,
then the remote can be moved away to the side, for example, to
drive up close to a table.
30
5.3 Adjustment options for the Modulite seat
unit

5.3.1 Adjusting the height of the armrests

Loosen the wing screw A.
1.
2. Set the armrest to the desired height.
3. Re-tighten the wing screw.

5.3.2 Adjusting the width of the armrests

WARNING!
Serious injury hazard if one of the armrests
falls out of its bracket because they have been
adjusted to a width which exceeds the permissible
value
– The width adjustment is fitted with small stickers with
markings and the word "STOP". The armrests must
never be pulled out further than the point at which
the word "STOP" is completely legible.
– Always tighten the fixing screws properly once
adjustments have been completed.
1578997-A