Using The Cane Holder; Using The Klickfix Adapter - Invacare TDX SP2 series User Manual

Invacare® TDX SP2® Series
4. The buckle should be positioned as centrally as possible. In doing
so, carry out adjustments on both sides as much as possible.
5. Check your belt every week to ensure that it is still in good
working condition, to ensure it has no damage or wear, and
that it is fixed properly to the mobility device. If the belt
is only fastened with a bolted connection, ensure that the
connection has not loosened or come undone. You can find
more information about maintenance work on belts in the
service manual, which is available from Invacare.

4.2 Using the cane holder

If your mobility device is fitted with a cane holder, it can be used for
the safe transport of a walking cane, underarm or forearm crutches.
The cane holder consists of a plastic container (bottom) and a Velcro
fastener (top).
CAUTION!
Risk of injury! A walking cane or crutches that
are not secured during transport (on the user's
lap, for example) can cause injury to the user or
other persons!
– During transport, walking canes or crutches should
always be secured using a cane holder!
1. Open the upper Velcro fastener.
2. Place the lower end of the walking cane or the crutches in the
container at the bottom.
3. The walking cane or the crutches can be secured at the upper
end using the Velcro fastener.

4.3 Using the KLICKfix adapter

Your mobility device can be fitted with the mini-adapter from the
Rixen + Kaul KLICKfix system. To this you can attach various
26
accessories such as the cellphone case supplied by Invacare, which
you can use to transport your cellphone, sports glasses etc.
Risk posed by unsecured accessories
Accessories can fall off and get lost if they are not
properly secured.
– Check that the accessory is correctly locked in and
seated securely every time you use the mobility device.
Risk of breakage due to excessive load
The KLICKfix adapter can break if too great a load is
applied.
– The maximum permitted load on the KLICKfix
adapter is 1 kg.
Securing the accessory:
1. Push the accessory into the KLICKfix adapter.
The accessory locks in securely.
Removing the accessory:
1. Press the red button and remove the accessory.
The adapter can turn in 90° steps, allowing you to attach an accessory
from any of four different directions. Please refer to the installation
1578997-A