Monitor Section - Roland M-5000 Reference Manual

Part Names and Functions

Monitor Section

This section is for working with monitor functions.
This unit is provided with two monitor systems.
The available selections for MONITOR 1 are 5.1, STEREO, and NONE (no assignment), and the available selections for MONITOR 2 are STEREO and
NONE (no assignment).
The unit is also provided with two solo systems. These are SOLO 1 for MONITOR 1 and SOLO 2 for MONITOR 2.
The input channel or output bus selected using [SOLO] on the top panel is sent to the monitor.
For details, refer to the "Monitor" section in the Reference Manual (PDF).
1 1
2 2
Number Name
1
[DISP] button
2
[SOLO IN PLACE] button
3
SOLO 1 / SOLO 2 [TRIM] knob
4
SOLO 1 / SOLO 2 [CLEAR] button
5
SOLO 1 / SOLO 2 [LAST] button
6
MONITOR 1 / MONITOR 2 [DIM] button
7
MONITOR 1 / MONITOR 2 [LEVEL] button
32
3 4 5 6
3 4 5 6
Description
This displays the MONITOR window.
This turns Solo in Place on and off. To turn on Solo in Place, press and hold this button for 2 seconds. It
flashes when on.
* When Solo in Place is on, a solo signal is sent to the output buses. Note that input channels where
solo is turned off are not output.
This adjusts the level of SOLO 1 or 2.
This clears SOLO 1 or 2. It flashes when a channel is currently soloed.
This turns the LAST mode on and off for SOLO 1 or 2.
This turns the dimmer on and off for MONITOR 1 or 2.
This adjusts the level of MONITOR 1 or 2.
7
7