Roland M-5000 Reference Manual page 107

Parameter Area of the SENDS Tab
Send point
Send pan to AUX
SEND PAN
* This is displayed when the AUX is stereo.
When PAN LINK is on, PAN to MAIN and SEND
PAN are linked.
PAN LINK
* This is displayed when the AUX is stereo.
Send level Send level sent to AUX
Selects from among the following as the send
point from input channel to AUX.
5 PRE-P
Pre-processing
5 PRE
Pre-fader
Send point
5 POST
Post-fader
* To change the send point, press the [SHIFT]
button, then go to the knob section area and
use the buttons or selected button to perform
the operation.
Turns sending to AUX on/off.
ON
Pressing and holding this sets the send level to
0.0 dB.
Memo
You can work with all 8 parameters at once by holding down the
[ALL] button and turning a knob or pressing a button.
SEND PAN
PAN LINK
ON
Send level
SETUP SENDS POINTS Window
In the SETUP SENDS POINTS window, you set send points to an AUX
for all input channels at one time.
KEEP Keeps the current send point settings.
Sets all input-channel send points to pre-
PRE PROC
processing.
PRE FDR Sets all input-channel send points to pre-fader.
POST FDR Sets all input-channel send points to post-fader.
Cancels any changes to send points and quits the
CANCEL
SETUP SENDS POINTS window.
Applies the changes to send points and quits the
SETUP SENDS POINTS window.
SET
All input-channel send points change.
CH EDIT Window
107