Roland M-5000 Reference Manual page 40

Part Names and Functions
18
AC INPUT Connector, Power-cord Clamp
This connector is for attaching the included power cord.
To keep the power cord from being inadvertently disconnected,
you use the power-cord clamp to secure the cord in place.
0"Connecting the Power Cord" (p. 16)
0"Using the Power-cord Clamp" (p. 16)
19
Power-cord Hook
You can use this power cord hook to prevent the power cord from
being accidentally disconnected.
0"Using the Power-cord Hook" (p. 18)
20
Cooling Fan
This is the fan for cooling the M-5000. When placing the M-5000, be
careful not to obstruct the ventilation holes.
21
EXT. POWER DC INPUT Connector
This connector is for attaching an optional S-240P external power-
supply unit to supply backup power to the M-5000.
If an S-240P External Power Supply Unit is providing power to the
M-5000, the M-5000 will keep operating even if the power switch is
in the OFF position.
* DC INPUT [DC+24V / 6A]
NOTE
To avoid damage or injury, never connect anything to the EXT.
POWER DC INPUT jack except the DC output of the S-240P
External Power Supply Unit.
22
INPUT 1–16 Connectors
These are female balanced XLR-3-31 input connectors for incoming
analog audio signals from microphones and line-level equipment.
* This instrument is equipped with balanced (XLR) type jacks.
Wiring diagrams for these jacks are shown below. Make
connections after first checking the wiring diagrams of other
equipment you intend to connect.
HOT GND
COLD
NOTE
Always turn the phantom power off when connecting any
device other than condenser microphones that require
phantom power. You risk causing damage if you mistakenly
supply phantom power to dynamic microphones, audio
playback devices, or other devices that don't require such
power. Be sure to check the specifications of any microphone
you intend to use by referring to the manual that came with it.
(This instrument's phantom power: DC+48 V, 14 mA Max)
40
+PHANTOM [+48V/14mA]
23
OUTPUT 1–16 Connectors
These are male balanced XLR-3-32 output connectors for sending
analog audio signals.
* This instrument is equipped with balanced (XLR) type jacks.
Wiring diagrams for these jacks are shown below. Make
connections after first checking the wiring diagrams of other
equipment you intend to connect.
1 2
GND HOT
COLD
24
EXPANSION SLOT
This slot is for installing an optional expansion interface.
0"Installing an Expansion Interface (Option)" (p. 24)
* When restarting the unit with the expansion interface installed,
wait for about one second before you turn on the power.