Recall Parameter Window; Recall Parameter List - Roland M-5000 Reference Manual

Scene Memory

RECALL PARAMETER Window

In the RECALL PARAMETER window, you set the recall range for
individual scenes.
To display the RECALL PARAMETER window, go to the SCENE
window and tap <FILT>.
Sets parameters on/off for the entire recall
ALL
parameter list.
FILTER ON Sets Recall Filter to be enabled/disabled.
CANCEL Discards settings and exits the window.
APPLY Applies settings and exits the window.
The following four tabs are displayed.
CHANNEL Here you set the input-channel recall range.
Here you set the DCA GROUP/output bus/MUTE
DCA/BUS
GROUP recall range.
FX/GEQ/INS
Here you set the FX/GEQ/INSERT recall range.
OTHER Here you set the CHANNEL LINK recall range.
Using Recall Filter
1.
Go to the SCENE screen and tap <FILT>.
The RECALL PARAMETERS window appears.
2.
Tap the tab where you want to set Recall Filter
(<CHANNEL tab>, <DCA/BUS tab>, <FX/GEQ/INS tab>, or
<OTHER tab>).
3.
In the recall parameter list, turn off parameters you want
to exclude from scene recall.
0"Recall Parameter List" (p. 178)
Selected parameters are excluded from recall in the scenes selected
in step 1.
178

Recall parameter list

Recall Parameter List
To set a range to recall, using Recall parameter list.
The information displayed changes as shown below depending
on what tab has been selected at the GLOBAL SCOPE window or
RECALL PARAMETER window.
CHANNEL tab
Channel number/Channel name
Channel number Channel number
Channel name
Channel name
Tapping this turns all parameters on the row on/
off.
You set the following parameters on/off for each column.
Parameters set to "off" are excluded from scene recall.
Sets Channel Safe on/off
SAFE
Input channels for which Channel Safe is turned
on are all excluded from scene recall.
NAME Input-channel name
PATCH Input patchbay
PREAMP Preamp settings
Φ Polarity
D.GAIN
Digital gain
FILTER HPF, LPF
DYN 1 Dynamics 1
DYN 2 Dynamics 2
EQ
4-band EQ
DELAY
Delay
INSERT A Channel insert
INSERT B Channel insert
DIRECT OUT Direct out (on/off, send point, level)
SENDS Sends to AUX
ROUTE Sends on/off to MAIN/SUBGROUP/MIX-MINUS
PAN Pan settings
MUTE
Muting
FADER Sends to MAIN
Tapping the header areas of the respective columns turns the entire
column on or off.