Time-Out Between Decodes, Same Symbol - Symbol LS 9100 Product Reference Manual

Parameters

Time-out Between Decodes, Same Symbol

This parameter sets the minimum time between decodes of the
same symbol. It is programmable in 0.1 second increments from
0.0 to 9.9 seconds. (Setting this above 0.4 seconds is
recommended.)
Scan the bar code below to select a new time-out. Next scan two
bar codes from Numeric Bar Codes beginning on page 5-160,
the first representing seconds, the second tenths of seconds. If
you make an error, or wish to change your selection, scan
CANCEL on page 5-170.
TIME-OUT BETWEEN SAME SYMBOL
5-95