Symbol LS 9100 Product Reference Manual page 26

8. Feed the scanner connector of the interface cable up
through the center of the mounting plate (if applicable),
and connect to the LS 9100.
9. Hold the scanner assembly by the holder posts so the
trough is facing left (and the scanner facing right).
10. Place the assembly onto the plate so the cylinder
underneath the holder is in contact with the wave spring
in the mounting plate.
11. Press the holder downward and rotate clockwise 90°
and release to lock the scanner assembly into the
mounting plate.
12. Proceed to
Counter Top Installation - Permanent Mounting
with Double-Sided Tape
Make sure your counter top is clean and dry before performing
these steps.
If the interface cable is going to be routed through the
1.
counter top only (and will not exit the rear of the holder
assembly):
a. Place the mounting plate on the counter top with the
arrow pointing in the direction the scanner will face.
b. Using the plate as your template, mark the center
cable hole. Remove the mounting plate.
c. Drill through the counter top in the center of the
cable hole mark using a 25.4 mm (1") drill bit.
Scanner Configuration on page
Setting Up the LS 9100
1-11.
1-9